This article outlines how to set up and configure MPC in your N Suite environment. This initial setup involves creating a Key Share Group for MPC and saving an individual Key Share to a mobile device.

Instructions

[Step 1] Accessing the Enable Button in N Board (Desktop Browser)

• Access Organization on the left hand bar, then Settings. You will find the Enable MPC button near the bottom of the settings.

• The screen will then say "Setting up your signing device". This means that you can now proceed to checking your mobile device where N Suite is installed. If you have not downloaded the N Suite mobile app, please do so using the QR code shown on your N Board screen. (Note that the screenshot below includes an altered QR code)

[Step 2] Creating Your Signing Key (N Suite Mobile App)

• Open the N Suite app on your mobile device, and tap Open on the in-app notification near the top that says Create Key for Signing. You may also tap the push notification on your mobile device, if you already have the N Suite app installed.

• Tap on Next

• The screen will indicate that your signing key is being prepared. Please allow a few minutes for this to complete

• Tap on Next

• Enter your Recovery Passphrase, then tap on OK

• Re-enter the Passphrase you had set in the previous step, then tap OK

• After securely storing your passphrase, read the disclaimer and tap the checkbox, then tap OK.

Step 3: Confirm that MPC is enabled on the settings screen.

• Go to the organizaton's settings screen once again, and confirm that it says Enabled under the MPC section.

This concludes the MPC enablement process. If you wish to have a user other than the user who enabled MPC submit requests or transactions, please refer to the article on granting MPC signing permission.